For the Neo Ergo, the chip is located on the daughterboard rather than the PCB.

  1. Turn off the battery toggle and take out the daughterboard from the bottom case.

  2. Open QMK Toolbox

    Releases · qmk/qmk_toolbox (github.com)

    image.png

  3. Use tweezers or paper clips to connect these 2 holes on the daughterboard (same 2 holes on the wired daughterboard). Then plug in, and don't remove contact until you see the yellow line in the QMK Toolbox

    Untitled

    Untitled

  4. Open and flash the firmware according to the version of your daughterboard

    Untitled

  5. Hit "Exit DFU" and you will see this ↓

    Untitled

  6. Unplug and replug to see if your board works now