<aside> 🚧 Notes:

This upgrade aims to boost the wireless performance of neo65 trimode PCB.

Preferably use a USB 2.0 interface. If a USB 2.0 interface is not available, a mouse extension cable can be used to migrate the interface.

Using USB 3.0 may cause latency issues. When plugging in with other receivers on the motherboard, try to avoid placing them side by side. It is best to separate them to eliminate interference.

</aside>

Upgrade Procedure:

1. Take out the PCB and daughterboard from the case and place it within 10cm of the back USB ports of your PC
2. Insert the 2.4GHz receiver
   1. Please download and run this app. Note: This app is only applicable to Neo65 keyboards purchased after August 2023. https://cdn.shopify.com/s/files/1/0508/8716/4061/files/2.4distance_59478941-82dd-4ee1-9668-01d06e8daa05.exe?v=1724905743
3. Entering Pairing mode with fn+tab then fn+r
4. Flash the latest firmware

   1. Neo65 Build Guide section 4 qwertykeys.com/pages/fw